In Manual Run Mode, you set deposition elevations for each Deposition Vector prior to a run.
There are two Manual Run Modes:
•Manual - Sequence: The DTM View updates following each Deposition Sequence .
•Manual - Raise: The DTM View updates following a Deposition Raise.
To activate a Manual Run Mode click:
•Click Deposition > Run Mode > Manual - Sequence; or
•Click Deposition > Run Mode > Manual - Raise; or
•Right click on the Run Button and click:
oManual - Sequence; or
oManual - Raise.
•Activate Deposition Sequences/Elevations:
oClick Edit > Deposition > Sequence; or
oClick the Deposition Sequence Button.
Deposition vectors and their Deposition Sequence are displayed on the Data Grid.
•To run a Manual Deposition Model:
oEnter the Deposition Elevation on the Data Grid.
Hints: •To set a constant raise elevation for all deposition points: ▪Right click on the Data Grid ▪Click Set Raise Elevations •Elevations are constrained by minimum and maximum bounds: ▪Minimum Elevation: Defined by Deposition Vector's intersection with surface topography ▪Maximum Elevation: Defined by the Raise Elevations and Deposition Vector intersections |